Auto-Video - NETGEAR XS708T User Manual

XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
The following table describes the MFDB Statistics fields.
Table 44. MFDB Statistics information
Field
Max MFDB Table Entries
Most MFDB Entries Since Last
Reset
Current Entries

Auto-Video

You can configure the auto-video settings.

To configure auto-video settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 10.
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching> Multicast > Auto-Video.
The Auto-Video Configuration page displays.
6. Select one of the following radio buttons:
• Select the Disable radio button to globally disable Auto-Video administrative mode for
the switch.
• Select the Enable radio button to globally enable Auto-Video administrative mode for
the switch.
The Auto-Video VLAN field shows the number of autoconfigured IGMP snooping VLANs.
7. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Description
The maximum number of entries that the Multicast Forwarding Database
table can hold.
The largest number of entries that were present in the Multicast Forwarding
Database table since last reset. This value is also known as the MFDB
high-water mark.
The current number of entries in the Multicast Forwarding Database table.
Configure Switching
166
Change the Default IP Address of the