NETGEAR XS708T User Manual page 207
8-port, 12-port, and 16-port
10-gigabit smart managed pro switch
Hide thumbs
Also See for XS708T:
- Hardware installation manual (32 pages) ,
- Installation manual (2 pages) ,
- Installation (2 pages)
Table of Contents
Advertisement
XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
6.
Select one or more interfaces by taking one of the following actions:
•
To configure a single interface, select the check box associated with the port, or type
the port number in the Go To Interface field and click the Go button.
•
To configure multiple interfaces with the same settings, select the check box
associated with each interface.
•
To configure all interfaces with the same settings, select the check box in the heading
row.
7.
From the IPv6 Mode menu, select Enable or Disable.
When IPv6 mode is enabled, the interface is capable of IPv6 operation without a global
address. In this case, an EUI-64-based link-local address is used. The default value is
Disable.
8.
From the DHCPv6 Client Mode menu, select to enable or disable the DHCPv6 client mode
on an interface.
Only one interface can function as a client. The default value is Disable.
9.
From the Stateless Address AutoConfig Mode menu, select to enable or disable the
stateless address autoconfiguration mode on an interface.
The default value is Disable.
10.
From the Admin Mode menu, select to enable or disable the IPv6 mode.
The default is Disable. When the IPv6 mode is enabled, the interface is capable of IPv6
operation without a global address. In this case, an EUI-64-based link-local address is
used.
11.
In the MTU field, specify the maximum transmit unit (MTU) for an interface.
If the value is 0, then this interface is not enabled for routing. It is not valid to set this value
to 0 if routing is enabled. The MTU range 1280 to 9198. The default is 1500.
12.
In the Duplicate Address Detection Transmits field, specify the number of duplicate
address detection (DAD) transmits on an interface.
The DAD transmits value must be in the range 0 to 600. The default is 1.
13.
In the Life Time Interval field, specify the router advertisement life time interval that is sent
from the interface.
This value must be greater than or equal to the maximum advertisement interval.
0 means do not use the router as the default router. The range of router life time is 0 to
9000. The default is 1800.
Configure Routing
207
Hide quick links:
Advertisement
Table of Contents
