To Disable A Rke Transmitter Linked To Memory - Jeep 2009 Commander Owner's Manual

Hide thumbs Also See for 2009 Commander:
Table of Contents

Advertisement

132 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To recall the memory setting for driver two, press
memory button number 2 on the driver's door, or the
UNLOCK button on the RKE transmitter linked to
memory position 2.
A recall can be cancelled by pressing any of the memory
buttons on the drivers door during a recall (S, 1, or 2).
When a recall is cancelled, the driver's seat, driver's
mirror, and the pedals stop moving. A delay of one
second will occur before another recall can be selected.

To Disable A RKE Transmitter Linked to Memory

1. Turn the ignition switch to the LOCK position, and
remove the key.
2. Press and release memory button number 1. The
system will recall any memory settings stored in position
1. Wait for the system to complete the memory recall
before continuing to Step 3.
3. Press and release the memory S (SET) button located
on the driver's door.
4. Within five seconds, press and release memory button
1 on the driver's door.
5. Within five seconds, press and release the UNLOCK
button on the RKE transmitter.
To disable another RKE transmitter linked to either
memory position, repeat steps 1 through 5 for each RKE
transmitter.
NOTE: Once programmed, all RKE transmitters linked
to memory can be easily enabled or disabled at one time.
Refer to Remote Linked to Memory under Electronic
Vehicle Information Center (EVIC) — Customer-
Programmable Features
information.
in Section 4 for more

Advertisement

Table of Contents
loading

Table of Contents