To Disable A Rke Transmitter Linked To Memory; Memory Position Recall - Jeep 2011 WK2 Grand Cherokee Owner's Manual

5. Turn the ignition switch to the OFF position
and remove the key.
6. Press and release the SET (S) button lo-
cated on the driver's door.
7. Within five seconds, press and release
MEMORY button 1 or 2 on the driver's door. The
next step must be performed within five sec-
onds if you desire to also use a RKE transmitter
to recall memory positions.
8. Press and release the LOCK button on one
of the RKE transmitters.
9. Insert the ignition key and turn the ignition
switch to the ON position.
10. Select Remote Linked to Memory in the
Electronic Vehicle Information Center (EVIC)
and enter Yes or select Use Factory Settings
from the EVIC and enter Yes . Refer to "Elec-
tronic Vehicle Information Center (EVIC)/
Customer-Programmable Features" in "Under-
standing Your Instrument Panel" for further
information.
102
11. Repeat the above steps to set the next
memory position using the other numbered
memory button or to link another RKE transmit-
ter to memory.

Memory Position Recall

NOTE:
The vehicle must be in PARK to recall
memory positions. If a recall is attempted
when the vehicle is not in PARK, a message
will be displayed in the Electronic Vehicle
Information Center (EVIC).
To recall the memory settings for driver one,
press MEMORY button number 1 on the driv-
er's door or the UNLOCK button on the RKE
transmitter linked to memory position 1.
To recall the memory setting for driver two,
press MEMORY button number 2 on the driv-
er's door or the UNLOCK button on the RKE
transmitter linked to memory position 2.
A recall can be cancelled by pressing any of
the MEMORY buttons on the driver's door dur-
ing a recall (S, 1, or 2). When a recall is
cancelled, the driver's seat, and driver's mirror
stop moving. A delay of one second will occur
before another recall can be selected.
To Disable a RKE Transmitter
Linked to Memory
1. Turn the ignition switch to the OFF position
and remove the key.
2. Press and release MEMORY button number
1. The system will recall any memory settings
stored in position 1. Wait for the system to
complete the memory recall before continuing
to Step 3.
3. Press and release the memory SET (S) but-
ton located on the driver's door.
4. Within five seconds, press and release
MEMORY button 1 on the driver's door.
5. Within five seconds, press and release the
UNLOCK button on the RKE transmitter.
To disable another RKE transmitter linked to
either memory position, repeat Steps 1-5 for
each RKE transmitter.