Vega VEGADIF 65 Operating Instructions Manual page 54

6 Adjustment with the indicating and adjustment module PLICSCOM
Copy sensor data
54
Part sum counter
▶ Mass flow
▶ Volume flow
Without unit
4
Select the requested variable with [->] and confirm with [OK].
5
Select calibration unit of the effective pressure transmitter with [-
>], for example m
Part sum counter
0 % = +0000
3
/s=
m
100 % = +0000
3
m /s=
6
Edit with [OK] and set the requested values with [+] and [->].
7
Confirm with [OK] and jump back to the indication of the part sum
counter.
8
Select with [->] the unit of the sum counter, adjust the requested
unit with [->], for example m
The setting of the part sum counter is hence terminated, the counting
function is activated.
The procedure of the total sum counter is the same.
This function enables reading out parameter adjustment data as well
as writing parameter adjustment data into the sensor via the indicating
and adjustment module. A description of the function is available in the
operating instructions manual "Indicating and adjustment module".
The following data are read out or written with this function:
Measured value presentation
l
Application
l
Unit of measurement
l
Adjustment
l
Damping
l
Linearisation curve
l
Creeping distance suppression
l
Sensor-TAG
l
Displayed value
l
Display unit
l
Language
l
The following safety-relevant data are not read out or written:
PIN
l
Copy sensor data
Copy sensor data?
3
/s and confirm with [OK].
3
/s and confirm with [OK].
VEGADIF 65 • Foundation Fieldbus