Position Of The Presser Foot; Adjusting The Rear Puller Device; Manual Lever; To Adjust The Puller Pressure - KANSAI SPECIAL DFB1404P Instruction

10- - - - 2 Position of the presser foot

10 10 10 2 Position of the presser foot 2 Position of the presser foot 2 Position of the presser foot
Fit the presser foot onto the presser bar so that the
needle can drop correctly to the center of the needle
drop hole on the presser foot.
Adjustment is made by loosening screw A.
The left-to-right play adjustment on the presser foot
is made by loosening nuts B.
Create a clearance of 0.5mm as shown in the
illustration on the right.
【11】ADJUSTING THE REAR PULLER DEVICE
11 11 11

11- - - - 1 Manual lever

1 Manual lever 1 Manual lever 1 Manual lever
To position or remove the fabric, raise manual lever
A.

11- - - - 2 To adjust the puller pressure

11 11 11 2 To adjust the puller pressure 2 To adjust the puller pressure 2 To adjust the puller pressure
The puller pressure should be as light as possible, yet
be sufficient to feed the fabric smoothly.
To increase the pressure, turn adjusting knob D
clockwise. To decrease the pressure, turn adjusting
knob D counterclockwise.

11- - - - 3 Adjusting the feeding amount of the rear puller

11 3 Adjusting the feeding amount of the rear puller
11 11 3 Adjusting the feeding amount of the rear puller 3 Adjusting the feeding amount of the rear puller
Adjust the feeding amount of the rear puller
according to that of the feed dog. To increase the
amount, loosen nut G and move it to the left. To
decrease the amount, move it to the right.
22