15- - - - 2 Adjusting the binder up and down
15
15
15
2 Adjusting the binder up and down
2 Adjusting the binder up and down
2 Adjusting the binder up and down
Adjust the binder up and down according to the
fabric to be used.
loosening screw A and wing screw I and turning
screw D as required.
After this adjustment is made, tighten screw A
and wing screw I.
< Note >
Adjust the position of J and K according to the
finished pin tuck.
15
15- - - - 3 Position of the upper and lower fingers of the binder
3 Position of the upper and lower fingers of the binder
15
15
3 Position of the upper and lower fingers of the binder
3 Position of the upper and lower fingers of the binder
Position upper and lower fingers so that distance
A is halved by each vertical center line of the
needles.
The line formed by the points of the upper and
lower fingers should be parallel with each
horizontal center line of the needles.
【16】CLEANING THE MACHINE
At the end of each day, remove the presser
foot and the needle plate and then clean the
slots of the needle plate and the area around
the feed dogs.
Adjustment is made by
29