Adjusting The Presser Foot; Presser Foot Pressure; Position Of The Presser Foot & Foot Lift - KANSAI SPECIAL V Series Instructions Manual

【9】ADJUSTING THE PRESSER FOOT

9 9 9 9 - - - - 1 Presser foot pressure

1 Presser foot pressure
1 Presser foot pressure 1 Presser foot pressure
The presser foot pressure should be as light as
possible, yet be sufficient to feed the fabric and
produce uniform stitches.
To increase the presser foot pressure, turn the
adjusting knob clockwise.
9 9 9 9 - - - - 2 Position of the presser foot & foot lift 2 Position of the presser foot & foot lift
2 Position of the presser foot & foot lift 2 Position of the presser foot & foot lift
Fit the presser foot onto the presser bar so that the
needle can drop correctly to the center of the
presser foot needle drop hole.
■Position of the presser foot
Loosen screw A.
Adjust by moving the presser foot left or right while
checking to make sure the needle drops correctly to
the center of the presser foot needle drop hole.
■Foot lift
For machines with the spreader, the presser foot
should be 5mm above the top surface of the needle
plate. Check to make sure presser foot does not
touch the spreader with the presser foot in the
above position.
spreader, the presser foot should be 6mm above the
top surface of the needle plate.
After the proper foot lift is achieved, fit collar B
onto the presser bar bushing and tighten screw C.
For machines without
12
the