Presser Foot; Presser Foot Pressure; Position Of The Presser Foot & Foot Lift - KANSAI SPECIAL MZ Series Instructions Manual

【9】PRESSER FOOT

9 9 9 9 - - - - 1 Presser foot pressure

1 Presser foot pressure
1 Presser foot pressure 1 Presser foot pressure
The presser foot pressure should be as light as
possible, yet be sufficient to feed the fabric and
produce uniform stitches.
To increase the presser foot pressure, turn the
adjusting knob clockwise.
9 9 9 9 - - - - 2 Position of the presser foot & foot lift 2 Position of the presser foot & foot lift
2 Position of the presser foot & foot lift 2 Position of the presser foot & foot lift
Fit the presser foot onto the presser bar so that the
needle can drop correctly to the center of the presser
foot needle drop hole.
■Position of the presser foot
Loosen screw A. Adjust by moving the presser foot
left or right while checking to make sure the needle
drops correctly to the center of the presser foot
needle drop hole.
■Foot lift
For machines with the spreader, the presser foot
should be 6mm above the top surface of the needle
plate. Check to make sure presser foot does not
touch the spreader with the presser foot in the above
position. For machines without the spreader, the
presser foot should be 8mm above the top surface of
the needle plate.
Set stopper B at the required position.
Fasten the presser foot lift lever with nut C so that
the lever cannot be lowered.
15