14- - - - 5 Adjusting the spreaders
14
14
14
5 Adjusting the spreaders
5 Adjusting the spreaders
5 Adjusting the spreaders
The clearance between spreader K,L and M and needles should be 1~1.2mm.
Spreader up-and-down adjustment is made with screws Q.
Spreader tilt adjustment is made with screws R.
【15】PTV MECHANISM
15
15- - - - 1 Disassembling and reassembling the binder
1 Disassembling and reassembling the binder
15
15
1 Disassembling and reassembling the binder
1 Disassembling and reassembling the binder
■ To disassemble the binder
Remove screw A. Remove the binder by pulling it
toward you while referring to arrows B and C.
< Note >
When removing the binder, be careful not to damage
the ends of the fabric guides.
■ To reassemble the binder
Fit the ends of upper fabric guides (F) onto lower
fabric guides (G). Move the binder down in the
direction of arrow H.
screw touches the bracket. Then tighten screw A.
Check that end D of the
28