【12】ADJUSTING THE FRONT PULLER DEVICE
12- - - - 1 To insert elastic and adjust the feeding amount of the front puller
12
1 To insert elastic and adjust the feeding amount of the front puller
12
12
1 To insert elastic and adjust the feeding amount of the front puller
1 To insert elastic and adjust the feeding amount of the front puller
Insert elastic by opening/closing small roller C with
lever A (see the illustration).
Adjust the feeding amount of the front puller
according to that of the feed dog.
To decrease the amount, loosen screw B and move it
up. To increase the move it down.
【13】ADJUSTING THE STITCH FORMATION
13
13- - - - 1 Thread tension adjustment
13
13
1 Thread tension adjustment
1 Thread tension adjustment
1 Thread tension adjustment
Thread tension varies according to sewing conditions
such as the fabric, thread and stitch length to be used.
Tension on the needle thread can be adjusted with
nuts A.
adjusted with nuts B. To increase the tension, turn
the nuts clockwise.
< Note >
The tension should be as light as possible, yet be
sufficient to produce uniform stitches.
13
13- - - - 2 Position of the needle thread
2 Position of the needle thread eyelets
13
13
2 Position of the needle thread
2 Position of the needle thread
■On 1402~1404, secure needle thread eyelet C at the
top end of the slot.
■On 1406~1412, secure needle thread eyelet C at the
center of the slot.
< Note >
Adjust the needle thread eyelets according to the thread
to be used.
To tighten the needle thread, raise the
needle thread eyelets.
Tension on the looper thread can be
eyelets
eyelets
eyelets
23