Table of Contents
Advertisement
8-2 Position of the presser foot & foot lift
Fit the presser foot onto the presser bar so that the
needle can drop correctly to the center of the presser
foot needle drop hole.
■Position of the presser foot
Loosen screw A. Adjust by moving the presser foot
left or right while checking to make sure the needle
drops correctly to the center of the presser foot
needle drop hole.
■Foot lift
The presser foot should be 8.5mm above the top
surface of the needle plate.
Set stopper B at the required position.
Fasten the presser foot lift lever with nut C so that
the lever cannot be lowered.
【9】ADJUSTING THE STITCH FORMATION
9-1 Position of the thread support
When the needle bar is at the bottom of its stroke,
the centers of the eyes on thread eyelet A should be
level with the top surface of thread support B, and A
should be parallel with B.
Height adjustment of thread support B is made by
loosening screw C and moving thread support B up
or down. Moving thread support B up tightens the
needle thread.
loosens the needle thread.
Moving thread support B down
9
H
D
X
H
D
X
s
e
r
i
e
s
s
e
r
i
e
s
Advertisement
Table of Contents
