Adjusting The Presser Foot Lift - KANSAI SPECIAL RX/UTC Series Instruction

【10】ADJUSTING THE PRESSER FOOT LIFT
■ F oot lift on the machine with spreader 6mm above the
top surface of the needle plate
■ F oot lift on the machine without spreader 7mm above
the top surface of the needle plate
To make the above adjustment, loosen screw D for
crank lever C and then set the clearance between slot
A on the presser bar clamp connection plate and screw
B at 0.5~1mm.
■ P neumatic presser foot lift
When the cylinder gets actuated, the presser foot
should be 6mm or 7mm above the top surface of the
needle plate.
cannot be lowered.
Then secure stopper E with nut F.
■ E lectric presser foot lift
When plunger H moves in direction of J, the presser
foot should be 6mm or 7mm above the top surface of
the needle plate. Adjust by using chain I.
Position stopper E so that lever G cannot be lowered.
Then secure stopper E with nut F.
Note that there is a little slack on chain I when
plunger H moves in the direction of K.
Position stopper E so that lever G
9