Position Of The Presser Foot; Adjusting The Rear Puller Device; Manual Lever; To Adjust The Puller Pressure - KANSAI SPECIAL DFB Series Instruction

1 0 - 2 P o s i t i o n o f t h e p r e s s e r f o o t
Fit the presser foot onto the presser bar so that the
needle can drop correctly to the center of the needle
drop hole on the presser foot.
Adjustment is made by loosening screw A.
The left-to-right play adjustment on the presser foot is
made by loosening nuts B.
Create a clearance of 0.5mm as shown in the
illustration on the right.
【11】ADJUSTING THE REAR PULLER DEVICE
1 1 - 1 M a n u a l l e v e r
To position or remove the fabric, raise manual lever A.
1 1 - 2 T o a d j u s t t h e p u l l e r p r e s s u r e
The puller pressure should be as light as possible, yet
be sufficient to feed the fabric smoothly.
To increase the pressure, turn adjusting knob D
clockwise.
knob D counterclockwise.
1 1 - 3 A d j u s t i n g t h e f e e d i n g a m o u n t o f t h e r e a r p u l l e r
Adjust the feeding amount of the rear puller according
to that of the feed dog. To increase the amount, loosen
nut G and move it to the left.
move it to the right.
To decrease the pressure, turn adjusting
To decrease the amount,
24