Table of Contents
Advertisement
4-9 After the extruder's temperature reaches 220 , the printer will sound a beep to
prompt you to load the filament into the extruder.
4-10 Insert the filament into the extruder at an upright angle. Then the filament will
be drawn through the extruder. Do not tap [Cancel] until the filament load the extruder
steadily.
4.4 Unloading Filament
(4-11) Tap [Tool]-[Unload] and the extruder starts heating up.
Finder User Guide | www.flashforge.com
4-9
4-10
4-11
28
0086-0579-82273989
Advertisement
Table of Contents
Need help?
Do you have a question about the finder and is the answer not in the manual?
Questions and answers