FLASHFORGE 3D PRINTER finder User Manual page 56

extruder before motor starts.
extruder temperature reachesto the printing temperature of
filament, the extruder temperature should reach 200 , after reaching the extruder
temperature, click the [Forward]/[Reverse]rotation button to control filament load
and filament unload. Furthermore, if you want to stop filament load and unload, you
can click[Stop].
Temperature Control: Input the temperature you want to get in the left frame,
click[Apply], the printer will automatically heat the corresponding part, the right side
shows the current actual temperature of corresponding part. After starting heating, the
below curve of temperature form will start to change, different color correspond
different parts' temperatures
Update Firmware
Every time when you start Flashprint, it will automatically detect and download the
up-to-date firmware. If any update is available, a dialog box will pop up for reminding
the users to update.
Step 1: Click [Tools]--[Update
updating firmware. If software and printer are already in connection, it reminds you
cutting off the connection, choose
Step 2: Choose corresponding printer type and firmware version and click
firmware updating box. After confirming the printer is in free state, the software will
automatically update the firmware
Finder User Guide | www.flashforge.com
Therefore, do not start rotation operation until the
firmware]. It needs to cut off connection before
and go on to the next step.
[Yes]
56
filament.For PLA
[OK] in the
0086-0579-82273989