Unloading Filament - FLASHFORGE 3D PRINTER Inventor II S User Manual

4-9
（4-9）After the extruder's temperature reaching 220℃, the printer will sound a beep
to prompt you to load the filament into the extruder.
4-10
（4-10） Insert the filament into the extruder at an upright angle. Then the filament will
be drawn through the extruder. Do not tap [Cancel] until the filament load the
extruder steadily.

4.4 Unloading Filament

4-11
(4-11) Tap [Tool]-[Unload] and the extruder starts heating up.
30
InventorIIS User Guide | www.flashforge.com