Table of Contents
Advertisement
(5-2) After tapping [Yes], the extruder starts to move towards the first point and
theplate moves up and down to verify the distance between nozzle and plate.
5-3
(5-3) When it shows that the distance is too big, please unscrew corresponding nut
under platform clockwise until hearing a steady beep and the [Verify] button appears.
5-4
(5-4) If the distance is appropriate, tap [OK] to second point leveling. If still not,
please follow the prompts to adjust again till you see [OK] button.
5-5
(5-5) Repeat steps 2 through 4 above to complete second and third points leveling and
then Tap [Finish] to exit.
Finder User Guide | www.flashforge.com
0086-0579-82273989
31
Advertisement
Table of Contents
Need help?
Do you have a question about the finder and is the answer not in the manual?
Questions and answers