FLASHFORGE 3D PRINTER finder User Manual page 49

Method 2: Press the shortcut Ctrl+Z.
Redo
Allows users to redo the most recent edit you have undone to your model file by the
following two methods
Method 1: Click [Edit]--[Redo]
Method 2: Press the shortcutCtrl+Y.
Empty Undo-stack
To clean up the recorded operating steps so as to release the memory.
Select All
By the following two methods, you could select all models in the scene. (When
models are too small to be seen or out of viewing scope, please click
[Center]and[Scale]buttons to adjust the model.)
Method 1: Click [Edit]--[Select
Method 2: Pressthe shortcut Ctrl+A.
Duplicate
Select the object and duplicate the object through the following two methods:
Method 1: Click [Edit]--[Duplicate]
Method 2: Press the shortcut
Delete
Select the object and delete the object through the following two methods:
Method 1: Click [Edit]--[Delete]
Method 2: Press the shortcut
Surface to Platform
Finder User Guide | www.flashforge.com
All].
Ctrl+D
Delete
49
0086-0579-82273989