Table of Contents
Advertisement
After finishing transferring, the printer will heat up automatically. And when heating
finishes, the print will start to build the model.
7.2.3Print from USB Flash Disk
Insert your USB flash disk with target .g or .gx file to your Finder. .
Turn on the Finder. Make sure the build plate has been leveled and the filament is
loaded.
Tap[Print]and then tap the
on the screen.Select the file you want to print and tap[Print]. The file will be
transferred to the printer.
And the printer will heat up the nozzle automatically and start to print after the
nozzle reaches the aimed temperature.,
Abort To stop heating and printing. Once you tap [Abort], the process is irreversible.
Pause To suspend the print job, you can tap it again to resume it. You can use this
function when you want to change the filament halfway.
Finder User Guide | www.flashforge.com
7-11
SD Card
icon in the middle. The file(s) will be displayed
63
0086-0579-82273989
Advertisement
Table of Contents
Need help?
Do you have a question about the finder and is the answer not in the manual?
Questions and answers