Table of Contents
Advertisement
Chapter 4: Hardware Assembly
Your Finder has been installed before leaving factory, you can start up the Finder for
printing after mounting the filament spool and completing leveling.
4.1 Filament Installation
(4-1) The filament cartridge is at the rear of Finder. Lift the cartridge out of the Finder.
(4-2) Take out the filament and thread it through the filament detecting equipment.
(Note: The filament should feeds from the bottom of the spool towards the top )
Finder User Guide | www.flashforge.com
4-1
4-2
25
Black Filament Detecting
Equipment
0086-0579-82273989
Advertisement
Table of Contents
Need help?
Do you have a question about the finder and is the answer not in the manual?
Questions and answers