Table of Contents
Advertisement
on the build area. Click[Back]and double-click the Moveicon again, then click
[On
the Platform] and
[Center]to ensure the model be on the platform.
7-4
Note If you've place your model in a right place, you can skip the step above.
(7-5) Click the Print icon on the top, you should make some setups for your print job.
7-5
Preview: If you check the [Preview] box, you can preview your model after slicing is
done.
Finder User Guide | www.flashforge.com
0086-0579-82273989
59
Advertisement
Table of Contents
Need help?
Do you have a question about the finder and is the answer not in the manual?