DencoHappel MATRIX OP21C Operation Manual page 92

Menu Structure OP5xx
−
Other menus (continued)
→
( 49)
−
−
−
1)
This menu is not available if MATRIX 4700 controls is used for standard and low-profile air handling units.
2)
This menu is only available if MATRIX 4700 controls is used with standard and low-profile air handling units.
92
2)
→
Air handling unit ( 70)
−
−
−
−
−
−
−
−
→
Service ( 79)
−
−
−
−
→
Full blocking ( 81)
−
→
Partial blocking ( 81)
−
→
Unit type ( 71)
−
→
Control mode ( 71)
−
→
Fans ( 71)
−
→
Energy recovery ( 75)
−
→
Air damper system ( 75)
−
→
Electric heater ( 76)
−
→
Direct evaporator ( 76)
−
→
Sensor inputs ( 75)
−
→
Sensor offset value ( 80)
−
→
Version info ( 80)
→
Change password ( 80)
Enter password
Enter password
PR-2011-0110-GB • Subject to modifications • R9-03-2016
MATRIX control panel
Unconfigured
Heating only
Cooling only
Heating+cooling
Unconfigured
Room temperature
Supply-air temperature
Room/supply air - cascade
Control mode
factor
Speed offset
Maximum volume flow
Disabled
Ecoflow 2-modulating
Ecoflow 3-modulating
Ecostat
Ecoplat
Ecorot
Ecorot 0..10 V
Disabled
Air volume flow
Mixing-air damper - automatic
M.A damper automatic + fan
Outside/extract air damper
Manual 2-point
Manual 3-point
Air volume
Automatic 2-point
Autom.+fan 2-point
Automatic 3-point
Autom.+fan 3-point
Disabled
1-speed
2-speed
3-speed
0..10 V
2..10 V
0..10 V+1-speed
0..10 V+2-speed
0..10 V+3-speed
2..10 V+1-speed
2..10 V+2-speed
2..10 V+3-speed
Disabled
1-speed
2-speed
0..10 Volt
10..0 Volt
Use
Input type
Range start
Range end
Filter constant end
K-factor
Offset value in °C or °F
Serial, Firmware, Hardware,
Bus system