ATTENTION
Follow ESD precautions.
NOTE
The CP8 blade is compatible only with the Brocade DCX and DCX-4S.
1.
Remove the chassis door
2.
Power off the blade you are replacing by sliding the slider switch in the top ejector down to the off position.
3.
Disconnect all cables from the CP blade you are replacing.
4.
Unscrew the thumbscrews from both ejectors using the Phillips screwdriver.
5.
Open both ejectors simultaneously to approximately 45 degrees and pull the CP blade out of the chassis.
FIGURE 32 Removal and replacement of the control processor blade (CP8)
Brocade DCX Backbone Hardware Installation Guide
53-1000685-24
(Removal and replacement of the chassis door
Removal and replacement of the control processor blade (CP8)
on page 83).
93