Replacing A Filler Panel - Brocade Communications Systems DCX Backbone Hardware Installation Manual

Removal and replacement of the blade filler panel
3. Pull the filler panel out of the chassis.
FIGURE 31 Removal and replacement of the blade filler panel

Replacing a filler panel

1. Orient the filler panel.
2. Slide the filler panel into the slot until it is firmly seated.
3. Tighten the thumbscrew at the bottom of the panel.
4. Replace the chassis door
90
(Removal and replacement of the chassis door on page 83).
Brocade DCX Backbone Hardware Installation Guide
53-1000685-24