Time And Items Required; Removing A Cable Management Comb - Brocade Communications Systems DCX Backbone Hardware Installation Manual

Time and items required

The replacement procedure for the cable management comb takes less than five minutes. A #1 Phillips screwdriver is required.

Removing a cable management comb

1. Remove the chassis door
2. Remove the cables from the cable management comb and rearrange the cables around the comb.
3. Unscrew and save the four (4) screws holding the comb to the chassis. Support the comb to prevent it from falling.
4. Remove the cable management comb.
FIGURE 29 Removal and replacement of the cable management comb
Brocade DCX Backbone Hardware Installation Guide
53-1000685-24
(Removal and replacement of the chassis door
Removal and replacement of the cable management comb
on page 83).
85