Table of Contents
Advertisement
FIGURE 9 Rack kit parts
1.
Tray, front, mid-mount, chassis
2.
Tray, rear, mid-mount, chassis
3.
Adapter, rear, mid-mount, right
NOTE
Not all parts may be used with certain installations depending on the device type.
Assembling the rack hardware
Perform the following steps to assemble the rack hardware.
1.
Attach the rear tray (with or without adapter, as required) to both rack rails. Orient the tray (refer the following figure) and use nine
screws (Item E) for each rail.
2.
Attach the front tray to both rack rails. Orient the tray
Brocade DCX Backbone Hardware Installation Guide
53-1000685-24
Installing the 14U Chassis Mid-Mount Rack Kit for Two-Post Racks (XBR-DCX-0121)
4.
Adapter, rear, mid-mount, left
5.
Screw, 10-32 x 3/8", pan head Phillips, ST, zinc (requires a torque of 32
inch-pounds)
(Figure
11) and use nine screws (Item E) for each rail.
41
Advertisement
Table of Contents
Troubleshooting
