Disconnecting From Network And Fabric - Brocade Communications Systems DCX Backbone Hardware Installation Manual

7. Enter licenseShow; then copy the command output into a text file named "licenseshow.txt."
switch:admin> licenseshow
S9bddb9SQbTAceeC:
Fabric license
eezeRRySff0fSe:
Remote Switch license
bzbzRcbcSc0c0SY:
Remote Fabric license
dSeR9RcSeeTfSAq:
Extended Fabric license
RyeSzRScycTzfT09:
Entry Fabric license
RyeSzRScycazfT0G:
Trunking license
RyeSzRScycS0fT09:
4 Domain Fabric license
8. Enter supportShow ; then copy the command output into a text file named "spptshow.txt."
NOTE
The supportShow command has a very long output and time for completion. It may last 20 minutes or longer
depending on the size of the SAN.
This file provides a backup of all the information that might be required by Technical Support. The information can be used after
the Brocade DCX is restored to the fabric to verify that no unintentional changes have occurred to the fabric.
switch:admin> supportshow
version: 6.0.0
<output truncated>
switch:admin>
9. Record the cable connections between the Brocade DCX and the target device and ports

Disconnecting from network and fabric

1. Shut down the Brocade DCX using the sysShutdown command.
switch:admin> sysshutdown
This command will shutdown the operating systems on your switch.
You are required to power-cycle the switch in order to restore operation.
Are you sure you want to shutdown the switch [y/n]?y
HA is disabled
Stopping blade 1
Shutting down the blade....
Stopping blade 4
Shutting down the blade....
Stopping blade 10
Shutting down the blade....
Broadcast message from root (pts/1) Tue Jul 18 14:23:06 2006...
The system is going down for system halt NOW !!
DANGER
Turn off the power switches and disconnect the power cords.
2. Power off the chassis by flipping all AC power switches to the off position. (The power supply status LED should turn off.)
3. Remove the power cords from the power supplies and the power outlets.
4. Label the cables connected to all blades and record the connections in
necessary.
5. Remove the chassis door
Brocade DCX Backbone Hardware Installation Guide
53-1000685-24
(Removal and replacement of the chassis door
Removal and replacement of the Brocade DCX chassis
(Cable routing table
Cable routing table on page 135 and additional copies if
on page 83).
on page 135).
129