Removal and replacement of the power supply
6.
If you are not replacing the power supply, insert a filler panel into the slot.
FIGURE 35 Removal and replacement of the power supply
Replacing a power supply
1.
Remove any filler panel.
2.
Insert the power supply into the slot. Verify that the power supply is seated by gently pulling on the handle. The power supply
should resist movement as you pull.
3.
Tighten the thumbscrew.
4.
Replace the power cord.
5.
Turn on the power switch.
102
Brocade DCX Backbone Hardware Installation Guide
53-1000685-24