Installing The 14U Rack Mount Kit For Four-Post Racks (Xbr-Dcx-0120 And Xbr-Dcx-0152) - Brocade Communications Systems DCX Backbone Hardware Installation Manual

Use the following steps to unpack, transport, and install the device.
1. Unpack and install the Brocade DCX.
a) Cut the bands that encircle the packaging.
b) Remove the lid and the kits and foam from the top of the chassis.
c) Lift the cardboard box off the chassis and remove the plastic bag from around the chassis. Save the packing materials for
use when returning the old chassis.
d) Leave the chassis on top of the plastic shipping tray if the chassis must be transported to the installation location.
NOTE
The Brocade DCX packaging does not incorporate a wood pallet and pallet brackets. The chassis sits on top of a
plastic shipping tray.
2. Use a pallet jack or other assisted lift to transport the new chassis to the installation area. Doorways must be wider than 91 cm
(36 in.) to accommodate the chassis.
3. Remove the 14U Rack Mount Kit, accessory kit, packing foam, and antistatic plastic from the chassis and set aside.
4. Install the rack mount kit in the rack using appropriate instructions in this Hardware Installation Guide.
5. Remove the chassis door from the Brocade DCX.
6. Remove the cable management comb.
7. Use a lift to raise the chassis to the correct level. Follow the instructions provided by the rack kit manufacturer.
8. If applicable, lock the wheels of the lift.
9. Gently slide the chassis onto the final installation surface, ensuring that it remains supported during the transfer.
10. Ensure that the chassis is oriented so that the nonport side has access to intake air (cool).
11. Reinstall the cable management comb.
12. If ICL cables will not be used, ensure that the ICL sockets in the core switch blades have EMI plugs inserted.
13. Reinstall the chassis door.
Installing the 14U Rack Mount Kit for Four-Post
Racks (XBR-DCX-0120 and XBR-DCX-0152)
Use the following instructions to install a modular device in a 19-in. (48.3 cm) EIA rack using the 14U Rack Mount Kit for Four-Post
Racks (XBR-DCX-0120 and XBR-DCX-0152).
Two rack-mount kits are available.
• XBR-DCX-0120 - Contains shelf brackets that telescope from 27 in. (68.58 cm) to 31 in. (78.74 cm) to fit the majority of
racks.
• XBR-DCX-0152 - Contains 22 in. (55.88 cm) fixed shelf brackets that adjust to 27 in. (68.58 cm).
Observe the following when mounting this device:
• Use Electronic Industries Association (EIA) standard racks. Ensure that the space in the 19-in. (48.3 cm) EIA rack is 14U high.
• Verify that the additional weight of the chassis does not exceed the weight limits of the rack.
• Before mounting your device, review any specific installation and facility requirements in this Hardware Installation Guide.
• Hardware devices illustrated in these procedures are only for reference and may not depict the device you are installing into the
rack.
Brocade DCX Backbone Hardware Installation Guide
53-1000685-24

Installing the 14U Rack Mount Kit for Four-Post Racks (XBR-DCX-0120 and XBR-DCX-0152)

31