Brocade Communications Systems DCX Backbone Hardware Installation Manual page 44

Installing the 14U Chassis Mid-Mount Rack Kit for Two-Post Racks (XBR-DCX-0121)
Perform the following steps to load the device into the mid-mount trays.
1. Ensure that the door is removed from the port side of the device. For instructions, refer to the door removal and replacement
procedures in your device installation guide.
2. Orient the device (refer the following figure) and use a hydraulic lift to raise it to the level of the trays.
3. If applicable, lock the wheels of the lift.
4. Slide the device into the trays until the front edge of the device is seated against the front tray.
FIGURE 12 Placing the device in the trays
1. Tray, front, mid-mount, chassis
5. Use three screws (Item 5) to attach each side of the rear tray to the device (refer the following figure).
NOTE
The screw holes in the device walls have pem nuts on the inside surface.
44
2. Tray, rear, mid-mount, chassis
Brocade DCX Backbone Hardware Installation Guide
53-1000685-24