Fujitsu UTB-GCA Operating Manual page 18

Individual control mode
Group control mode
All control mode
Notes
• In order to shorten the setting time as well as to simplify the setting procedure, it is possible to send all of
the set information by pressing
FLOW OF OPERATION".)
• The time between each press of the buttons should be less than 1 minute, otherwise, after five time of
Beep sound. (in 30 seconds) all the changes that have been made will disappear.
• To be used to change the settings of a single
remote control group.
• To be used to change the settings of remote
controller groups in group control unit.
• Only the central control numbers (the indoor
units) that have been stored in the group ap-
pear on the LCD, when the group is selected.
• When the central control numbers that have
been stored in the group are not all included in
that one page of LCD, the relevant page num-
ber will also come on when the group is se-
lected.
• If groups are composed of indoor units of HEAT
PUMP TYPE refrigerant system,
appear on the LCD.
• To be used to change the settings of all remote
control groups that have been stored in the cen-
tral remote controller.
SET
after all the changes have be made. (Refer to "3-1. BASIC
will
17