Engine Oil Filter - VESPA GTS Super 300 ie 2008 Service Station Manual

Vespa GTS Super 300 ie (2008)
and if necessary top up without exceeding the
MAX level. The cartridge filter must be replaced
every time the oil is changed. Use new oil of the
recommended type for topping up and changing
purposes.
N.B.
THE ENGINE MUST BE HOT WHEN THE OIL IS CHANGED.
Recommended products
eni i-Ride PG 5W-40 Synthetic based lubricant
for high-performance four-stroke engines.
JASO MA, MA2 - API SL - ACEA A3
Check
This operation must be carried out with the engine cold and following the procedure below:
1. Place the vehicle on its centre stand and on flat ground.
2. Undo cap/dipstick "A", dry it off with a clean cloth and replace it, screwing down completely.
3. Remove the cap/dipstick again and check that the level is between the min and max. marks; top-
up, if required.
The MAX level mark indicates a quantity of around 1300 cc of engine oil. If the check is carried out after
the vehicle has been used, and therefore with a hot engine, the level will be lower; in order to carry out
a correct check, wait at least 10 minutes after the engine has been stopped so as to get the correct
level.
Engine oil top-up
The oil should be topped up after having checked
the level and in any case by adding oil without
ever exceeding the MAX. level.
Restoration of the level from MIN to MAX requires
approximately 200 cc.

Engine oil filter

Change oil and replace filter as indicated in the scheduled maintenance table. Use new oil of the rec-
ommended type for topping up and changing purposes.
Make sure the pre-filter and drainage plug O-rings are in good conditions. Lubricate them and refit the
mesh filter and the oil drainage plug, screwing them up to the specified torque. Refit the new cartridge
filter being careful to lubricate the O-ring before fitting it. Change the engine oil.
Recommended products
eni i-Ride PG 5W-40 Synthetic based lubricant for high-performance four-stroke engines.
Maintenance
MAIN - 51