Head Lubrication Control Jet - VESPA GTS Super 300 ie 2008 Service Station Manual

Vespa GTS Super 300 ie (2008)
Engine
Specification
Cubic capacity
Stroke
MAX. torque
Max. Power
Timing system
Compression ratio
Engine idle speed
Air filter
Starting system
Lubrication
Fuel system
valve clearance
Minimum lubrication pressure (100° C)
Lubrication pressure
Cooling
Specification
Distance between the rotors
Axial rotor clearance
Distance between the outer rotor and the pump body
Levelness
Specification
Plunger diameter
By-pass check up: Standard length
Calibration pressure
Specification
OIL MINIMUM PRESSURE INDICATOR LIGHT SWITCH
Specification
Calibration
Specification
Diameter
* Tightening torque 5÷7 N·m
Specification
Cooling system capacity
Recommended fluid
Sealing pressure
Type
Bore
OIL PUMP
Type
BY-PASS
Type
OIL FILTER
Type

HEAD LUBRICATION CONTROL JET

COOLING SYSTEM
DATA
Desc./Quantity
single-cylinder, four-stroke and four liquid-cooled valves
22 Nm at 6500 rpm
16.4 kW at 7500 rpm
single overhead camshaft, chain-driven, on the left-hand side,
three-arm rocking levers set up with threaded set screw
1650 ± 50 rpm
sponge, impregnated with mixture (50% petrol and 50% oil)
electric starter motor with freewheel
with lobe pump (inside the crankcase) chain-driven and double
filter: mesh and paper
Electronic injection with electric fuel pump
intake: 0.10 mm - exhaust: 0.15 mm
Forced-circulation coolant system.
Desc./Quantity
Admissible limit clearance: 0.12 mm
Limit values admitted: 0.09 mm
Admissible limit clearance: 0.20 mm
Desc./Quantity
Ø 13.9 - 0.039 -0.057 mm
Desc./Quantity
Paper with pressure relief and anti-drain back by-pass valves
Desc./Quantity
Desc./Quantity
1 ± 0.05 mm *
Desc./Quantity
~ 2.100 ÷ 2.150 l
AGIP PERMANENT SPEZIAL
Cap calibrated at 0.9 bar
Characteristics
278.3 cm³
63 mm
75 mm
10.5 ÷ 11.5
0.8 bar
3.5 to 4 bar
Trochoidal
0.1 mm
With piston
54.2 mm
4.5 bar
0.3 - 0.6 bar
CHAR - 9