Engine Oil Filter - VESPA Primavera 125 Manual

Vespa Primavera 125 i.e. - 150 i.e. 3V ABS (i-get 2016)
Maintenance
Engine oil 10W-40 Synthetic lubricant for four
stroke engines (0°C< T <45°C)
SAE 10W-40; JASO MB, MA, MA2; API SL
Check
This operation must be carried out with the engine cold and following the procedure below:
- Place the vehicle on its centre stand and on flat ground.
- Undo cap/dipstick, dry it off with a clean cloth and reinsert it, screwing down completely.
- Remove the cap/dipstick again and check that the level is between the MIN and MAX reference marks;
top-up, if required.
The MAX level mark indicates a quantity of around 1,220 cm³ of engine oil. If the check is carried out
after the vehicle has been used, and therefore with a hot engine, the level will be lower; in order to carry
out a correct check, wait at least 10 minutes after the engine has been stopped so as to get the correct
level.
Engine oil top-up
The oil should be topped up after having checked
the level and in any case by adding oil without
ever exceeding the MAX. level.

Engine oil filter

Change oil and replace filter as indicated in the scheduled maintenance table. Use new oil of the rec-
ommended type for topping up and changing purposes.
Make sure the pre-filter and drainage plug O-rings are in good conditions. Lubricate them and refit the
mesh filter and the oil drainage plug, screwing them up to the prescribed torque. Refit the new cartridge
filter being careful to lubricate the O-ring before fitting it. Change the engine oil.
Recommended products
Engine oil 10W-40 Synthetic lubricant for four stroke engines (0°C< T <45°C)
SAE 10W-40; JASO MB, MA, MA2; API SL
MAIN - 56