VESPA GTS Super 300 ie 2008 Service Station Manual page 48

Maintenance
0.7 to 0.8 mm
Electric characteristic
Spark plug
NGK CR8EKB
Locking torques (N*m)
Spark plug
12 ÷ 14
Hub oil
Check
-Place the vehicle on the centre stand on flat
ground;
- Remove the oil dipstick «A», dry it with a clean
cloth and put it back into its hole tightening it
completely;
Remove the dipstick and check that the oil level is
slightly over the second notch starting from the
lower end; if the level is under the MAX. mark, it
needs to be filled with the right amount of hub oil.
-Screw up the oil dipstick again and make sure it
is locked properly into place.
Replacement
-Remove the oil filler cap «A».
- Unscrew the oil drainage cap «B» and drain out
all the oil.
- Screw in the drainage cap again and fill the hub
with the prescribed oil.
Recommended products
AGIP GEAR SAE 80W-90 Lubricant for gear-
boxes and transmissions.
API GL-4
Characteristic
Rear hub oil
Capacity approximately 250 cc
MAIN - 48
Vespa GTS Super 300 ie (2008)