VESPA GTS Super 300 ie 2008 Service Station Manual page 247

Vespa GTS Super 300 ie (2008)
Removal
- Remove the front wheel
- Pre-loosen the two fixing pins of the brake pads
- Remove the brake calliper
- Remove permanently the two pad fixing screws
- Check that there are no flaws or warping. If there
is, replace it.
- Check the thickness of the friction material is
more than 1.5 mm. If it is not, replace it
- The replacement must be made with greater re-
sidual thickness if the pad has not worn evenly. A
0.5 mm thickness difference in the residual friction
material is permitted
Refitting
To fit, proceed as follows:
- Insert the two pads in the callipers.
Braking system
BRAK SYS - 247