Engine Oil Filter - VESPA S 50 4T 4V (2008) Manual

Vespa S 50 4T 4V (2008)
Replacement
Loosen the oil filler plug.
- Unscrew the drainage plug from the mesh filter
on the flywheel side, and let the oil drain off.
- Tighten the drainage plug and refill with ~
600-650 cm³ of oil.
Check
Park the vehicle on a level surface and rest it on
its stand (cold engine).
- Check that the oil level is between the MAX and
MIN marks on the dipstick.
- The MAX level reference indicates ~ 850 cm³ in
the engine.
- If the oil level is close to the MIN mark, top-up by
adding oil but do not exceed the MAX level.
Recommended products
AGIP CITY HI TEC 4T Oil to lubricate flexible
transmissions (brakes, throttle control and od-
ometer)
Oil for 4-stroke engines

Engine oil filter

- Change oil when the engine is hot.
- Place a container under the oil sump and remove
the oil drainage cap.
- After draining the oil, clean the mesh filter with a
specific solvent and then blow it with compressed
air.
- The filter can be reached after removing cap
"A" (see figure).
Maintenance
MAIN - 41