Removing The Starter Motor - VESPA GTS Super 300 ie 2008 Service Station Manual

Vespa GTS Super 300 ie (2008)

Removing the starter motor

- Remove the two screws indicated in the figure
- Take the starter motor out of its seat
Removing the flywheel magneto
- Remove the water pump shaft and crankshaft
spline clip
- Line up the two holes in the flywheel as shown in
the picture
- Screw in the guide bushing that is part of the
special flywheel stop tool on the flywheel as shown
in the picture
Engine
ENG - 147