VESPA GTS Super 300 ie 2008 Service Station Manual page 116

Engine from vehicle
This section describes the operations to carry out when removing the engine from the scooter.
Exhaust assy. Removal
- Remove the right and left fairings and the spoiler terminals.
- Remove the Lambda probe from its support and
disconnect it.
Remove the clamp holding the lambda probe ca-
ble to the coolant pipe indicated in the photograph
- Undo the two exhaust manifold fixings on the
head. To unscrew the nuts that fix the silencer
flange to the head properly, use a jointed wrench
that allows, according to the travel direction, to get
also at the right nut. That is difficult to do with a
traditional straight wrench.
- Undo the three screws that fix the silencer to the
supporting arm.
- Remove the full silencer unit.
ENG VE - 116
Vespa GTS Super 300 ie (2008)