VESPA GTS Super 300 ie 2008 Service Station Manual page 180

Injection
1
2 Throttle body and electronic injection control unit (MIU)
3 Diagnostics socket connector
4
5 Water temperature sensor
6
7
8
9
10 Injection load remote control
11
12 Electric fan remote control
MIU injection system
This vehicle is fitted with an integrated injection and ignition system.
Injection is indirect in the manifold through an electro-injector.
The injection and ignition are timed on the four-stroke cycle by means of a tone wheel keyed on to the
crankshaft (24-2 teeth) and pick-up sensor.
Combustion and ignition are managed on the basis of engine revs and throttle valve opening. Further
corrections are made according to the following parameters:
- Coolant temperature.
- Intake air temperature
- Lambda probe
The system implements cold engine idle fuel/air mixture correction with a stepper motor on a by-pass
circuit of the throttle valve. The control unit manages the Stepper motor and the injector opening time,
thereby ensuring the idle steadiness and the proper combustion.
In all conditions of use, mixture preparation is managed by modifying the injector opening time.
The fuel pressure is kept constant in relation to ambient pressure.
The fuel system circuit consists of:
- Fuel pump
- Fuel filter
- Injector
- Pressure regulator
The pump, the filter and the regulator are placed inside the fuel tank on a single support.
The injector is connected by a pipe with fast-release fittings. The pressure regulator is located at the
beginning of the circuit.
The fuel pump is controlled by the MIU control unit; this ensures safety of the vehicle.
The ignition circuit consists of:
- HV coil
- HV cable
- Shielded cap
- MIU control unit
INJEC - 180
C
OMPONENT
Specification
Instrument panel
Fuel pump
Fuel injector
HV coil
Engine Speed sensor
Lambda Probe
Battery
Vespa GTS Super 300 ie (2008)
T
RANSPOSITION
Desc./Quantity
12V - 12 Ah