Displaying And Maintaining Proxy Arp; Proxy Arp Configuration Examples; Common Proxy Arp Configuration Example - HP 3600 v2 Series Configuration Manual

Hide thumbs Also See for 3600 v2 Series:
Table of Contents

Advertisement

Displaying and maintaining proxy ARP

Task
Display whether common proxy
ARP is enabled.
Display whether local proxy ARP is
enabled.

Proxy ARP configuration examples

Common proxy ARP configuration example

Network requirements
As shown in
Host D are 192.168.10.100/16 and 192.168.20.200/16 respectively), but they are located on different
subnets separated by the switch (Host A belongs to VLAN 1 while Host D belongs to VLAN 2). As a result,
Host D cannot receive or respond to any ARP request from Host A.
You must configure proxy ARP on the switch to enable communication between the two hosts.
Figure 8 Network diagram
Configuration procedure
# Create VLAN 2.
<Switch> system-view
[Switch] vlan 2
[Switch-vlan2] quit
Figure
8, Host A and Host D have the same IP prefix and mask (IP addresses of Host A and
Command
display proxy-arp [ interface interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
display local-proxy-arp [ interface
interface-type interface-number ] [ | { begin
| exclude | include } regular-expression ]
16
Remarks
Available in any view
Available in any view

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents