Configuring Ftrace For A Tunnel; Displaying Ftrace For A Tunnel - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual
Hp storageworks fabric os 6.x administrator guide (5697-0015, may 2009)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Administrator's manual (576 pages) ,
- Hardware reference manual (256 pages) ,
- User manual (248 pages)
Table of Contents
Advertisement
Table 74
FTRACE configurable parameters
Parameter
Trace Mask
Trigger Mask
After information is captured, you can use the portshow command to display FTRACE information on a
GE port for a tunnel. You can save trace events can for future analysis.
Configuring ftrace for a tunnel
Use the following syntax to configure a trace:
portcfg -ftrace [slot-number] ge port number [tunnel -id] cfg|del] <opt
args>
To enable a trace :
1.
Log on to the switch as admin.
2.
Enter the portcfg -ftrace command with the following options:
portcfg-ftrace ge0 cfg -a 0 -e 1
This disables Auto Checkout and enables trace for GigE 0, tunnel 1
To delete a configuration for a tunnel:
1.
Log on to the switch as admin.
2.
Enter the portcfg -ftrace command with the following options:
portcfg-ftrace ge1 1 del
This deletes the configuration for tunnel 1.
Displaying ftrace for a tunnel
The portshow command uses the ftrace option to display a trace for a tunnel.
Use the following syntax to display a trace:
portshow -ftrace [slot-number] ge port number [tunnel -id] cfg|del]<opt
args>
To display the trace for a tunnel:
1.
Log on to the switch as admin.
2.
Enter the portshow-ftrace command with the following options:
portshow-ftrace ge0 -stats
This displays the trace stats for the GE port 0 for tunnel 1.
NOTE:
The configuration file includes key FCIP FTRACE configuration values. Configurations are stored
on a slot basis and not on blades, such as the FR4- 1 8i. If the FR4- 1 8i is swapped, the configuration stays
the same for the new FR4- 1 8i corresponding to the slot they are plugged in.
When performing a configdownload, the FCIP configuration is applied to the switch only on a slot
power OFF or ON, for example slots containing the FR4- 1 8i. The HP StorageWorks 400 MP Router, which
is not slot based, requires a reboot. See the Fabric OS Command Reference for more information on any of
these commands.
Default
0x8000
0x00000003
Range
Syntax
0-0xFFFFFFFF
Integer
0-0xFFFFFFFF
Integer
Fabric OS 6.x administrator guide 321
Advertisement
Table of Contents
Troubleshooting
