Dip Switch Settings - Bolin Technology VCC-2HD10S-SN User Manual

DIP SWITCH SETTINGS

The bottom dip switch is for setting the camera configuration for following items:
1. Camera ID Address for RS-485 PELCO protocol
2. Video output / Video color space
3. RS-232 / RS-422/485 selection
4. RS-232 / RS-422/485 baud rate
5. Video resolutions selection
6. IR remote controller ID
Setting of the BOTTOMDIP Switches
Turn off power to the camera before changing the DIP switch settings.
Power on the camera to have the new Dip Switch setting activated.
From the above list, No.1 Camera ID address and NO.2 Video resolution settings can be set in camera OSD menu as
well. The camera takes either the way of OSD menu setting or the way of bottom DIP switch setting. They override each
other. After the camera is turned on, the camera takes the last setting before it is turned on, either set through the OSD or
bottom DIP switch.
The Bottom DIP Switch Settings
SWI: Factory Default Setting: ON, OFF, OFF, OFF, OFF, OFF, OFF, ON.
Bit1~3: Camera Address setting for VISCA protocol
Bit4: Video Output/Video Color Space
Bit5: Reserve
Bit6: RS-232/RS-422
Bit7~8: RS-232/RS-422 Baud Rate
1. Camera Address setting for VISCA protocol
B1
ON
OFF
ON
OFF
ON
OFF
ON
2. Video Output/Video Color Space
When using HDMI output to display on HDMI device, set the Dip switch B4 to OFF.
When using HDMI to DVI convertor to have DVI video output, set the Dip switch B4 to ON.
3. RS-232 / RS-422 Setting
B2
OFF
ON
ON
OFF
OFF
ON
ON
B4
OFF
ON
B6
OFF
ON
B3
OFF
OFF
OFF
ON
ON
ON
ON
Color Space Setting
RS-232 / RS-422
16
Address
1 (Default)
2
3
4
5
6
7
YUV
RGB
RS-232
RS-422