Removing the NE1032 from a Lenovo System x or Power
Rack
1. Disconnect all external cables.
2. If the air-duct option has been installed, remove it as described in
3. Loosen and remove M3.5 screws that secure the rear brackets to the front brackets.
4. Loosen and remove the M6 screws, washers, and clip nuts (or cage nuts) that attach
5. Slide the rear mounting brackets out of their slots in the front mounting brackets.
64
NE1032 Installation Guide
This section describes how to remove the NE1032 from a Lenovo System x or Power
4-post rack.
To remove the NE1032 from a System x or Power rack, complete the following steps:
Air-Duct Option" on page
the filler plate and rear mounting brackets to the rear rack posts.
9
68.
3
10
7
8
"Removing the
5