Configuring Local Pbr To Specify Output Interface And Next Hop - HP MSR Series Configuration Manual

The debugging information about PBR displayed on Router A is as follows:
<RouterA>
*Jun
success : POLICY_ROUTEMAP : lab1, Node : 20, next-hop : 151.1.1.2
*Jun
success : POLICY_ROUTEMAP : lab1, Node : 20, next-hop : 151.1.1.2
*Jun
success : POLICY_ROUTEMAP : lab1, Node : 20, next-hop : 151.1.1.2
*Jun
success : POLICY_ROUTEMAP : lab1, Node : 20, next-hop : 151.1.1.2
The preceding information shows that Router A sets the next hop for the received packets to
151.1.1.2 according to PBR. The packets are forwarded through Serial 2/1.

Configuring local PBR to specify output interface and next hop

Network requirements
As shown in
The downlink port of the router is connected to the hosts, and its uplink port Ethernet1/1 is
•
connected to the Internet.
• The subinterface Ethernet 1/1.1 obtains its IP address through DHCP.
Configure local PBR so that the router forward SNMP packets and SNMP traps through the subinterface
Ethernet 1/1.1.
Figure 78 Network diagram
Configuration procedure
# Configure the subinterface Ethernet1/1.1 to obtain its IP address through DHCP.
<Router> system-view
[Router] interface ethernet 1/1.1
[Router-Ethernet1/1.1] ip address dhcp-alloc
[Router-Ethernet1/1.1] vlan-type dot1q vid 1
[Router-Ethernet1/1.1] quit
# Configure ACL 3000 to match SNMP packets and SNMP traps.
[Router] acl number 3000
[Router-acl-adv-3000] rule 0 permit udp source-port eq snmp
[Router-acl-adv-3000] rule 5 permit udp destination-port eq snmptrap
[Router-acl-adv-3000] quit
7 12:06:47:631 2009 RouterA PBR/7/POLICY-ROUTING: IP policy based routing
7 12:06:48:630 2009 RouterA PBR/7/POLICY-ROUTING: IP policy based routing
7 12:06:49:627 2009 RouterA PBR/7/POLICY-ROUTING: IP policy based routing
7 12:06:50:627 2009 RouterA PBR/7/POLICY-ROUTING: IP policy based routing
Figure 78:
271