Configuring An Additional Metric For A Rip Interface - HP MSR Series Configuration Manual

# On Router B, define ACL 2000 and reference it to a filtering policy to filter routes redistributed
from RIP 100, making the route not advertised to Router C.
[RouterB] acl number 2000
[RouterB-acl-basic-2000] rule deny source 10.2.1.1 0.0.0.255
[RouterB-acl-basic-2000] rule permit
[RouterB-acl-basic-2000] quit
[RouterB] rip 200
[RouterB-rip-200] filter-policy 2000 export rip 100
# Display the routing table on Router C.
[RouterC] display ip routing-table
Routing Tables: Public
Destination/Mask
11.1.1.0/24
12.3.1.0/24
12.3.1.2/32
16.4.1.0/24
16.4.1.1/32
127.0.0.0/8
127.0.0.1/32

Configuring an additional metric for a RIP interface

Network requirements
As shown in
D, and Router E.
Router A has two links to Router D. The link from Router B to Router D is more stable than that from Router
C to Router D. Configure an additional metric for RIP routes received from Ethernet 1/2 on Router A so
Router A prefers route 1.1.5.0/24 learned from Router B.
Figure 7 Network diagram
Configuration procedure
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure basic RIP:
# Configure Router A.
<RouterA> system-view
[RouterA] rip
Destinations : 7
Proto
RIP
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Figure 7, run RIPv2 is enabled on all the interfaces of Router A, Router B, Router C, Router
Routes : 7
Pre Cost NextHop
100 1 12.3.1.1
0 12.3.1.2
0 127.0.0.1
0 16.4.1.1
0 127.0.0.1
0 127.0.0.1
0 127.0.0.1
39
Interface
Eth1/1
Eth1/1
InLoop0
Eth1/2
InLoop0
InLoop0
InLoop0