Configuring Bfd For Ospf - HP MSR Series Configuration Manual

[RouterA-ospf-1] filter-policy 2000 import
[RouterA-ospf-1] quit
# Display the OSPF routing table of Router A.
[RouterA] display ip routing-table
Routing Tables: Public
Destination/Mask
3.1.1.0/24
3.1.2.0/24
10.1.1.0/24
10.1.1.1/32
10.2.1.0/24
10.2.1.1/32
10.3.1.0/24
10.4.1.0/24
127.0.0.0/8
127.0.0.1/32
The route to 10.5.1.1/24 is filtered out.

Configuring BFD for OSPF

Network requirements
As shown in
OSPF is enabled on Router A, Router B, and Router C so that they are reachable to each other at
•
the network layer.
After the link over which Router A and Router B communicate through a Layer 2 switch fails, BFD
•
can quickly detect the failure and notify OSPF of the failure. Router A and Router B then
communicate through Router C.
Figure 27 Network diagram
Device
Router A
Destinations : 10
Proto
O_ASE
O_ASE
Direct 0
Direct 0
Direct 0
Direct 0
OSPF
OSPF
Direct 0
Direct 0
Figure 27:
Interface IP address
Eth 1/1 192.168.0.102/24
Eth 1/2 10.1.1.102/24
Routes : 10
Pre Cost NextHop
150 1 10.2.1.2
150 1 10.2.1.2
0 10.1.1.1
0 127.0.0.1
0 10.2.1.1
0 127.0.0.1
10 4 10.1.1.2
10 13 10.2.1.2
0 127.0.0.1
0 127.0.0.1
Device
Router B
107
Interface
Eth1/2
Eth1/2
Eth1/1
InLoop0
Eth1/2
InLoop0
Eth1/1
Eth1/2
InLoop0
InLoop0
Interface IP address
Eth 1/1 192.168.0.100/24
Eth 1/2 13.1.1.1/24