Configuring Bfd For Ospfv3 - HP MSR Series Configuration Manual

[RouterC-Ethernet1/1] quit
3. Verify the configuration:
# After all routers function correctly, perform a master/backup switchover on Router A to trigger
an OSPFv3 GR operation.

Configuring BFD for OSPFv3

Network requirements
As shown in
Configure OSPFv3 on Router A, Router B and Router C and configure BFD over the link Router
•
A<—>L2 Switch<—>Router B.
After the link Router A<—>L2 Switch<—>Router B fails, BFD can quickly detect the failure and
•
notify OSPFv3 of the failure. Then Router A and Router B communicate through Router C.
Figure 91 Network diagram
Device
Router A
Router C
Configuration procedure
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure OSPFv3 basic functions:
# Configure Router A. Enable OSPFv3 and configure the router ID as 1.1.1.1.
<RouterA> system-view
[RouterA] ipv6
[RouterA] ospfv3 1
[RouterA-ospfv3-1] router-id 1.1.1.1
[RouterA-ospfv3-1] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] ospfv3 1 area 0
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] ospfv3 1 area 0
Figure 91:
Interface IPv6 address
Eth1/1 2001::1/64
Eth1/2 2001:2::1/64
Eth1/1 2001:2::2/64
Eth1/2 2001:3::1/64
Device Interface
Router B Eth1/1
Eth1/2
320
IPv6 address
2001::2/64
2001:3::2/64