HP MSR Series Configuration Manual page 323

# Display OSPFv3 neighbor information on Router C.
[RouterC] display ospfv3 peer
OSPFv3 Area ID 0.0.0.0 (Process 1)
----------------------------------------------------------------------
Neighbor ID
2.2.2.2
OSPFv3 Area ID 0.0.0.2 (Process 1)
----------------------------------------------------------------------
Neighbor ID
4.4.4.4
# Display OSPFv3 routing information on Router D.
[RouterD] display ospfv3 routing
E1 - Type 1 external route,
E2 - Type 2 external route,
OSPFv3 Router with ID (4.4.4.4) (Process 1)
------------------------------------------------------------------------
*Destination: 2001::/64
Type : IA
NextHop : FE80::F40D:0:93D0:1
*Destination: 2001:1::/64
Type : IA
NextHop : FE80::F40D:0:93D0:1
*Destination: 2001:2::/64
Type : I
NextHop : directly-connected
*Destination: 2001:3::/64
Type : IA
NextHop : FE80::F40D:0:93D0:1
3. Configure Area 2 as a stub area:
# Configure Router D.
[RouterD] ospfv3
[RouterD-ospfv3-1] area 2
[RouterD-ospfv3-1-area-0.0.0.2] stub
# Configure Router C, and specify the cost of the default route sent to the stub area as 10.
[RouterC] ospfv3
[RouterC-ospfv3-1] area 2
[RouterC-ospfv3-1-area-0.0.0.2] stub
[RouterC-ospfv3-1-area-0.0.0.2] default-cost 10
Pri State
1 Full/DR
Pri State
1 Full/Backup
IA - Inter area route,
* - Selected route
311
Dead Time Interface
00:00:35 S2/0
Dead Time Interface
00:00:36 S2/1
I
Cost
Interface: S2/1
Cost
Interface: S2/1
Cost
Interface: S2/1
Cost
Interface: S2/1
Instance ID
0
Instance ID
0
- Intra area route
: 2
: 3
: 1
: 4